TM 9--2520--215--34
DETERMINING NOMINAL SHIMS FOR OUTPUT BEVEL DRIVEN GEAR
BEARING RETAINER CONTINUED
0020 00
DETERMINING NOMINAL SHIMS FOR OUTPUT BEVEL DRIVEN GEAR BEARING RETAINER Continued
NOTE
Record measurement from housing being used because each housing is stamped with its
specific dimension.
7. Record dimension indicated by F on figure 1 or 2. This dimension is stamped on a web (7) at the left side of the
transmission housing.
D ---5.212
E---9.560
F
---9.985
7
8. Determine nominal shim pack thickness by substituting dimensions recorded in 4 through 7, above, for Y, Z, MD
and F in the following formula: (MD + Y + Z) F = nominal shim pack thickness.
9. Assemble output drive shaft as outlined on WP 0077 00.
10. Install assembled drive shaft group (and brake coolant pump assembly) into transmission as outlined on
WP 0076 00.
END OF TASK
0020 00--5/6 blank