TM 9--2520--215--34
REPAIR STANDARDS
0019 00
THIS WORK PACKAGE COVERS:
Repair Standards
FIT AND WEAR LIMITS
Data covering fit and wear limits is given in each work package. Points of measurement are indicated in the Check
Points column in each work package.
T--TIGHT ; L--LOOSE
Check Points column includes the manufacture dimensions and tolerances and fits of mating parts. T denotes a
tight (interference) fit; L denotes a loose (clearance) fit.
MEANING OF WEAR LIMIT
Wear limits indicate dimension to which a part may wear before it is replaced. Normally, any part not worn beyond
its wear limit will be approved for continued service if it is not otherwise damaged.
STANDARD TORQUE LISTING
Standard torque to which bolts, nuts, and screws are to be tightened are listed in WP 0086 00. These are normal
values. Any special torque values are listed in the copy pertinent to applicable parts.
END OF TASK
0019 00--1/2 blank
