TB 43-0213
Rocker
g. Drilling
P a n e l s (Typical) (see
e. Drilling Rear of Doors
(Typical) (see
(10.2 cm) above top of door trim. Existing hole B can
be used for lower door area.
TA504825
Figure 6-7. Drilling Rocker
Panels (Typical),
TA504823
NOTE
Figure 6-5. Drilling Rear of
Doors (Typical).
In Figure 6-8, holes E, F, G, H, and I do not
apply to the Ml 009.
f . Drilling Front Lower Door and Doorjamb
doorjamb to 1/2 inch (1.3 cm). Holes B are to be sight
Body
Support
h. Drilling
Channels (see
drilled at bottom front of doors.
G, H, and I are existing holes which must be enlarged to
1/2 inch (1.3 cm). All other access holes are large
enough to receive tools.
i. Drilling Top of Doorjamb (see Figure 6-9), Drill
a total of four holes in the top of both doorjambs.
(1) Drill holes A 12 inches (30.5 cm) from top
of doorjamb openings.
(2) Drill holes B 16 inches (40.6 cm) from holes
A. Holes A and B cover all models.
(3) Model M 1009 only. Drill a total of four
holes. Drill hole C even with rubber bumper, both
doorjambs. Drill holes D and E 9 inches (22.9 cm)
from seatbelt bolt.
TA504824
Figure 6-6. Drilling Front Lower Door and
Doorjamb (Typical).
6-3
