TB 43-0213
i. Drilling Top Side Rails (see Figure 14-10), Drill
j. Cutting Bottom of Stake Pockets (see
six holes A in the underside of each top side rail on the
dump body. The holes are on a centerline that is
(3. 8 cm) radius at the bottom of each stake pocket
located 1 5/8 inch (4 cm) from the outer edge of the rail,
gusset. The radii are to be cut on both sides of the
The holes are centered 1 inch (2.5 cm) to the front and
gusset. Repeat steps on opposite side of vehicle.
the rear of the stake pocket gussets.
TA504894
Figure 14-10. Drilling Top Side Rails.
TA504895
Figure 14-11. Cutting Bottom of Stake Pockets.
14-5
