TB 43-0213
CHAPTER 17
M911 SERIES TRACTOR
Section I. PRELIMINARY PROCEDURES
(1) Cab headline panel.
17-1. Component Removal.
(2) Steel door trim panels,
a. The M911 Series Tractor discussed in this
(3) Batteries.
chapter is illustrated in Figure 17-1.
(4) Side engine panels.
b. Prior to rustproofing, remove the following
components from the M911 Series Tractor (see
TM 9-2320-270-20):
TA504908
Figure 17-1. M911 Series Tractor.
Section Il. DRILLING AND CLEANING PROCEDURES
17-2. Drilling Procedures.
holes A in the top and the side of the cowl. Holes
NOTE
should be sight drilled. Repeat for other side.
Unless otherwise indicated, all holes should
c. Drilling Rear Cab Braces (see Figure 17-3). Drill
be sight drilled and should be 1/2 inch
four holes A in cab braces on each side. Holes should
(1.3 cm) in diameter.
be sight drilled.
drilling instructions.
17-1
