TB 5-2520-551-24
PTO UNIT (cont.)
On PTO unit, place cable housing in mounting bracket on PTO assembly.
26.
Cable should have enough slack with no kinks to keep it from rubbing
against engine or firewall.
Under dashboard, reinstall nut holding PTO actuator cable to dashboard.
27.
Using 3/4" combination wrench, hold cable housing. Using 3/4" combination
wrench, tighten nut.
Install nut and knob on end of PTO cable using 9/16" combination wrench.
28.
Pull PTO actuator cable out of housing about half way in truck cab.
29.
On PTO unit, remove cable housing from bracket. Mark point to cut on cable
30.
housing. Using diagonal cutting pliers, cut cable housing. Cable housing
end should not be crimped closed after cutting.
Place cable housing in bracket on PTO unit. Using a 1/2" combination
31.
wrench, hold bolt. Using a 7/16" combination wrench, tighten nut onto
bolt.
12
