PTO ACTUATOR CABLE (cont.)
TB 5-2520-551-24
On PTO unit, place cable through hole in bolt at end of actuator arm.
34.
Using a 1/2" combination wrench, hold actuator arm bolt. Using a 1/4"
combination wrench, tighten nut securing cable to bolt in actuator arm.
Cut off excess cable about one inch past actuator arm, using diagonal
35.
cutting pliers. Bend end of cable at a right angle to actuator arm using
slip joint pliers.
In truck cab, engage and disengage PTO control knob to insure cable travel.
36.
Inside engine compartment, apply RTV (MIL-A-46106, type 1) to hole where
37.
PTO actuator cable passes through firewall.
14
