TM 9--2520--215--34
0038 00--1
STEER CLUTCH HOUSING ASSEMBLY REPLACEMENT
0038 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0088 00)
Hoist (2000 lb lifting capacity min)
Torque wrench (item 29, WP 0088 00)
Materials/Parts
Lockwasher (18) (item 32, WP 0087 00)
Gasket (item 28, WP 0087 00) (right side)
Gasket (item 42, WP 0087 00) (left side)
Equipment Conditions
Steer control valve body assembly removed
(WP 0026 00)
Inspection hole cover and gasket removed
(WP 0036 00)
NOTE
There are two steer clutch housing assemblies, left and right. Both steer--clutch assemblies
are removed and installed in the same manner. These procedures show the right steer clutch
housing assembly only. Differences will be noted.
Note the quantity, size, and location of hardware during removal to aid in installation.
REMOVAL
1. Attach hoist and remove 19 mounting bolts (1) and 18 lockwashers (2) from right steer clutch housing (3). Install
two mounting bolts (1) as jacking screws into threaded holes (4). Loosen right steer-- clutch housing (3) from
transmission by tightening jacking screws (1). Discard lockwashers.
1
2
4
3
1
