DISASSEMBLY (cont) - TM-9-2520-215-34

DISASSEMBLY (cont) - TM-9-2520-215-34_158

DISASSEMBLY (cont) - TM-9-2520-215-34_160

TM-9-2520-215-34 Recovery Vehicle Full Tracked: Heavy M88A2 (NSN 2350 01 290 4683) Manual
Page Navigation
144

TM 9--2520--215--34 0039 00--7 STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED 0039 00 DISASSEMBLY – Continued 14. Using two 3/8 –24 bolts as lifters, remove steer clutch piston (28) assembly from housing (4) hub. 28 4 NOTE Do not remove lubrication valve unless replacement is necessary. 15. Remove lubrication valve (32) by drilling end of pin (33) where it is peened into clutch piston (28). Using an 11/32--inch drill, drill a 3/16--inch--deep hole in exact center of the pin. Locate a suitable punch in center of hole and drive out pin. Discard pin. 33 32

Privacy Statement
Press Release
Contact