TM 9--2520--215--34
0039 00--12
STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED
0039 00
CLEANING
See WP 0018 00for cleaning procedures.
INSPECTION
See WP 0018 00 for general inspection and repair recommendations.
FIT AND WEAR LIMITS
Check the following parts to the dimensions listed. Replace if not within dimensions specified.
PART NAME
CHECK POINTS
ACCEPTABLE LIMITS
Output bevel driven gear
Bearing, inner race
Bearing, outer race
Output planetary--carrier assembly
Output planetary--carrier spindle
Thrust washer
Spindle roller
Outer planetary pinion
Output planetary sun gear
Ball bearing
Left steer--tie--shaft gear
Internal splined center plate
OD of outer hub at bearing face
Bearing press fit on gear
ID of bearing cone
Bearing press fit on gear
OD of bearing
Bearing fit in bore
Diameter at bearing surface
OD at center of spindle
Thickness
OD
Slip fit, 22 rollers on spindle
ID
ID at bearing surface
Bearing fit
OD
Bearing fit
ID
Bearing fit
Plate thickness
5.5032 to 5.5035 in.
Maximum wear: 5.5027 in.
0.0022T to 0.0035T in.
5.5000 to 5.5010 in.
0.0022 to 0.0035 in.
9.5000 to 9.5010 in.
0.0010T to 0.0020L
3.3464 to 3.3471 in.
Wear limit: 3.3461 in.
1.5127 to 1.5132 in
Wear Limit: 1.5117 in.
0.0590 to 0.0620 in.
Wear Limit: 0.0550 in.
0.2498 to 0.2500 in.
Wear limit: 0.2493 in.
0.0005 to 0.0019 in.
Wear limit: 2.0152 in.
2.0137 to 2.0142 in.
7.8728 to 7.8742 in.
Wear limit: 7.8748 in.
0.0012T to 0.0014L
7.8728 to 7.8740 in.
0.0012T to 0.0014L
7.8728 to 7.8740 in.
Wear limit:7.8748 in
0.0012T to 0.0014L
0.1580 to 0.1630 in.
Wear limit: 0.1380 in.
