TM 9--2520--215--34
0039 00--14
STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED
0039 00
FIT AND WEAR LIMITS – Continued
Check the following parts to the dimensions listed. Replace if not within dimensions specified.
PART NAME
CHECK POINTS
ACCEPTABLE LIMITS
Left and right steer clutch housing--
Continued
Bearing fit to bore
ID valve sleeve bore in housing
Sleeve fit in housing
Housing ID at bearing surface
Bearing fit in housing
0.0005T to 0.0011L
1.7483 to 17493 in.
0.0002T to 0.0022T
5.1179 to 5.1189 in
0.0002T to 0.0016L
ASSEMBLY
NOTE
Steps 1 through 3 apply to left hand steer clutch housing assembly on XT--1410--5A transmission.
On the XT--1410--5A transmission perform steps 1 through 3 and steps 7 through 42.
On the XT--1410--4 transmission, begin with step 1.
1. Install sleeve (55) with two new self--locking bolts (54) into housing (4). Tighten bolts 36 to 43 lb.--ft.
2. Install oil tube assembly (52) and elbow (53) into housing (4).
3. Install pipe plug (51) into housing (4). Go to step 7.
4
51
53
52
54
55
