TM 9--2520--215--34
0039 00--15
STEER CLUTCH HOUSING ASSEMBLY REPAIR CONTINUED
0039 00
ASSEMBLY Continued
4. Install sleeve (49), threaded end first, through new seal ring (50) and then into bore in housing (4). Install nut
(48), flat side first, into sleeve (49). Torque nut to 150 to 200 lb--ft. Stake thin outer lip of nut into mill slot of
sleeve.
5. Install elbow (46) into threaded end of sleeve (49). Install elbow (47) into nearest tapped hole in housing (4).
Tighten both elbows until tube assembly can be fitted properly into elbows. Elbows are positioned toward front of
housing at an elevation of approximately 24 degrees above horizontal.
50
47
49
4
48
46
6. Install tube assembly (43). Tighten nuts at ends of tube assembly.
43