TM 9--2520--215--34 0039 00--13 STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED 0039 00 FIT AND WEAR LIMITS – Continued Check the following parts to the dimensions listed.  Replace if not within dimensions specified. PART NAME CHECK POINTS ACCEPTABLE LIMITS External splined clutch plate Steer clutch hub Steer clutch drive gear Ball bearing Spacer Spacer Steer clutch apply ring Ball bearing Steer clutch lube valve Ball bearing Oil transfer sleeve Left and right steer clutch hous- ing Plate thickness ID Bearing fit ID at bearing surface Bearing fit ID Bearing fit Thickness Thickness ID ID OD Bearing fit OD Sleeve fit Combined valve and sleeve ID OD Carrier fit Housing fit OD Large OD of inner hub at bearing surface Bearing fit on hub Large OD of inner hub at bearing surface Bearing Bearing fit on hub Steer drive shaft bore OD 0.1200 to 0.1250 in. 7.8728 to 7.8742 in. Wear limit: 7.8784 in. 0.0012T to 0.0014L 7.8728 to 7.8742 in. Wear limit: 7.8748 in. 0.0012T to 0.0014L 5.1171 to 5.1181 in. 0.0003T to 0.0017L 0.1240 to 0.1300 in. Wear limit: 0.1200 in. 0.1240 to 0.1300 in. Wear limit: 0.1200 in. 7.8728 to 7.8742 in. Wear limit: 7.8748 in. 0.0012T to 0.0014L 5.1171 to 5.1181 in. 7.8728 to 7.8740 in. 0.0012T to 0.0014L 1.3735 to 1.3740 in. 0.0018L to 0.0028L Wear limits: 0.0031L 3.3457 to 3.3465 in 5.1173 to 5.1181 in. 0.0014T to 0.0001L 0.0002T to 0.0016L 1.300 to 1.301 in 5.1164 to 5.1174 in Wear limit: 5.1159 5.1060 to 5.1110 in. Wear limit: 5.1021 in. 0.0061L to 0.0121L 3.5428 to 3.5438 in. Wear limit: 3.5422 in.