TM 9--2520--215--34
0039 00--9
STEER CLUTCH HOUSING ASSEMBLY REPAIR – CONTINUED
0039 00
DISASSEMBLY – Continued
NOTE
Do not remove the outer races from the steer--tie--shaft, tie--shaft--idler and steer--drive--shaft
bearing unless replacement is necessary. If replacement is necessary, perform step 18.
Do not remove such minor parts as bolts, lifting bracket, and plugs unless replacement is
necessary.
18. Hook bearing race out with a heeled tool. Place heel of tool against bottom of recess in housing and pry under
edge of race. While right housing contains a tie--shaft--idler bearing outer race, left housing does not.
NOTE
Do not remove four pinion spindles unless replacement is necessary. Perform step 19 if
replacement is necessary.
19. Position outer planetary carrier assembly (5) shaft upward, in an arbor press. Press out four spindles (37) from
pinions (38), catching spindle lock balls (39) as they fall free. Remove pinions (38), two thrust washers (40), and
needle bearing rollers (41).
5
37
39
38
41
40
40
