TM 9--2520--215--34
0048 00--2
BRAKE HOUSING ASSEMBLY REPAIR – CONTINUED
0048 00
CLEANING
See WP 0018 00 for cleaning procedures.
INSPECTION
See WP 0018 00 for general inspection and repair recommendations.
FIT AND WEAR LIMITS
Check the following parts to the dimensions listed. Replace if not within the specified dimensions.
PART NAME
CHECK POINTS
ACCEPTABLE LIMITS
Brake wear plate
Thickness of plate
0.2440 to 0.2470 in.
ASSEMBLY
NOTE
Position wear plate so that rivet heads will fit into countersink of holes.
1.
Place wear plate (3) against inside surface of brake housing assembly (2) flange. Align four new formed rivets (1)
with holes in flange. Use C--clamps to hold wear plate (3) in position.
2.
Drive four new formed rivets (1) from wear plate (3) side of brake housing assembly (2) flange.
1
2
3
NOTE
FOLLOW--ON MAINTENANCE:
Install brake housing assembly
(WP 0043 00).
END OF TASK
