TM 9--2520--215--34
0047 00--8
OUTPUT REDUCTION GEAR OUTPUT SHAFT AND RELATED PARTS REPAIR
– CONTINUED
0047 00
ASSEMBLY – Continued
CAUTION
Use extreme care not to touch polished radial sealing face of ring of seal with bare hands or tools.
Index hole in ring with pin in flange.
11. On the XT--1410--5A transmission, press pin (12) into face of output shaft assembly (1). Pin must protrude 0.19
inches from face of output shaft assembly (1).
12. Install spacer (5), larger diameter first, onto output shaft assembly (1). Lubricate new preformed packing (7) with
oil soluble grease and install into outer groove of spacer (5). Press outer ring (8) sealing face up, over spacer (5)
and new preformed packing (7).
4
5
7
1
12
---5A MODEL
ONLY
13. Lubricate new small preformed packing (6) with oil soluble grease and roll onto groove of small end of oil seal
replacer. Assemble oil seal replacer over output shaft assembly (1) and roll new preformed packing (6) onto
bearing journal. Use end of oil seal replacer to push new preformed packing (6) inside diameter groove of spacer
(5).
1
6
5
