TM 9--2520--215--34
0047 00--4
OUTPUT REDUCTION GEAR OUTPUT SHAFT AND RELATED PARTS REPAIR
– CONTINUED
0047 00
INSPECTION
See WP 0018 00 for general inspection and repair recommendations.
FIT AND WEAR LIMITS
Check the following parts to the dimensions listed. Replace if not within the specified dimensions.
PART NAME
CHECK POINTS
ACCEPTABLE LIMITS
Output shaft
Roller bearing
Shaft small bearing surface OD
Bearing fit on shaft
Shaft large bearing surface OD
Bearing OD
Bearing fit on shaft
Bearing ID
Fit of bearing on shaft
1.3771 to 1.3776 in.
Wear limit: 1.3769 in.
0.0001T to 0.0009L
5.1187 to 5.1194 in
Wear limit: 5.1182 in.
9.0539 to 9.0551 in.
0.0000 to 0.0030L
5.1171 to 5.1181 in
0.006T to0.0023T
ASSEMBLY
NOTE
All related items not covered below are installed into output reduction gear assembly as
outlined in WP 0045 00. No repair of those parts is necessary.
The first step in assembly of the shaft in the XT--1410--5A transmission is step 11. The
XT--1410--5A transmission does not contain any studs in the output shaft assembly.
